- 2018-02-01 17:00:25
HMG100-TP Coal Shearer
HMG100-TP Hydraulic Haulage Shearer is the thinnest coal shearer in China. This hydraulic shearer is applicable to the 0.4-0.9m coal thickness.
Cutting height: 440~900mm
Dip angle of coal seam: <35°
Coal hardness: f≤ 3
HMG100-TP Hydraulic Haulage Shearer
1. Brief Introduction
HMG100-TP Hydraulic Haulage Shearer is the thinnest shearer in China. The body of it is short and narrow. It’s used in the coal seam that is 0.4~0.9m ,coal property is medium-hard ( f ≤3) and the slope angle<35°, the maximum slope angle can be 45°as your requirement. When the slope angle>18°,the machine needs to add the Non-slip winch. It can be used with scraper conveyors and hydraulic prop in the conventional mining working face.
2.1 This hydraulic haulage shearer uses “three tracks” coal mining working. Because it can climb on the floor of whole body, the requirements for corollary equipment such as transport and support are not high.The cost of general machinery and equipment would be lower.
2.2 The machine itself has a loading mechanism. The coal cutted by spiral drum is transfered to conveyor by loading machine. And the result of coal loading is good.
2.3 The powerful motor power and good mechanical strength can cut hardish coal seam and with low gangue coal seam.
2.4 The body machine is short, and the thickness of machine is the thinnest in China compared with the same power shearers,the cutting height is lowest.
2.5 It is easy to operate for concentrated operators and buttons.
2.6 The tractive force is large. Hydraulic traction systems are reliable. Hydraulic components of good performance is easy to replace.
2.7 With spray device,the dust removal result is good.
2.8 The good performance shearer machine and the sample and reliable structure make coal shearer easy to maintain. It is suitable for small mines.
3. HMG100-TP Technical Parameters
The length of the machine
The height of the machine
The width of the machine
driving chain sprocket and drum shaft are not included in
HSGD420/22 OR HSGB420/30
Machine height（including joist 20）
370 ( YR) /330
( part 350)(YRA)
Total installed power
Rotate speed of drum shaft
Depth of cut
Mode of traction
Hydraulic anchor chain traction
The specification of chain
∮18 x 64 、 ∮ 22 x 86
The breaking force chain
410 、730 (C class)
Single hydraulic prop